The following questions should be considered in the formulate of zinc die casting process:
(1) The liquid metal can cleanly and smoothly flow in the gating system, and does not produce eddy current separation.
(2) Is there no sharp or dead zones exist?
(3) Is there a change in the section area of the gating system?
(4) Is the location of the vent and spillway trough correct? Is it big enough? Whether it will be blocked? Whether Gas can be effective and smooth discharge?
Using computer simulation of filling process is to analyze the above phenomenon, in order to make a reasonable choice of zinc die casting parameters.
The above article from KENOS official website (http://www.kenos-diecasting.com/) kenosblog1511
The original address: http://www.kenos-diecasting.com/news_show_126.html, reproduced please specify.
(1) The liquid metal can cleanly and smoothly flow in the gating system, and does not produce eddy current separation.
(2) Is there no sharp or dead zones exist?
(3) Is there a change in the section area of the gating system?
(4) Is the location of the vent and spillway trough correct? Is it big enough? Whether it will be blocked? Whether Gas can be effective and smooth discharge?
Using computer simulation of filling process is to analyze the above phenomenon, in order to make a reasonable choice of zinc die casting parameters.
The above article from KENOS official website (http://www.kenos-diecasting.com/) kenosblog1511
The original address: http://www.kenos-diecasting.com/news_show_126.html, reproduced please specify.
没有评论:
发表评论